Your position: > Products > Governor > ESC series >
ESC5330 Genset governor

ESC5330 Genset governor

  • publish: 2014-02-26 15:50      Browse:
  • Type:     ESC5330
  • Product Summary:
  •       The ESC5330 series speed control unit is rugged enough to be placed in a control cabinet or engine mounted enclosure with other dedicated control equipment.The circuit board is conformally coated to seal out moisture and resist vibration.If water,mist or condensation can come in contact with the controller,it should be mounted vertically.This will allow any accumulated fluids to drain away from the speed control unit....

Introduce
Product:
User manual:
Software Download:

Product description:

The ESC5330 Generator speed control unit is rugged enough to be placed in a control cabinet or engine mounted enclosure with other dedicated control equipment.The circuit board is conformally coated to seal out moisture and resist vibration.If water,mist or condensation can come  in contact with the controller,it should be mounted vertically.This will allow any accumulated fluids to drain away from the speed control unit.

It is  designed to precisely control engine speed and provide fast precise response to transient engine loads.A complete closed loop control system is formed with the addition of a magnetic pickup signal sensing engine speed and 24volt DC power.


Main features:

1、The basic characteristics of the engine speed controller ESC5330 "start fuel" and "fuel slope" adjustment, these properties will reduce the smoke exhaust through the engine operating speed previously reached. 

2、This controller has two speed switch (an overspeed protection, a starter motor stopping point) 

3、Can be independently controlled acceleration and deceleration rate when the rate of speed. 

4、transfer rate and other features include adjustable idle work, to assist with the input between multiple machines or special purpose machines, to prevent a short circuit fault reverse battery voltage, transient voltage, the actuator and the loss of speed sensor signal or an protective case under power. 

5、ESC5330 series GAC speed controller for all inter-actuator includes ACE100 actuators. When ESD5330 series between speed controller with the ADC100 Series electric actuators when, "DROOP" speed range will be less between these actuators low current requirements. In this case the application ESC5331.


Specifications:

Input Supply: 24 ± 20% VDC battery systems ( transient and reverse voltage protected) 

Polarity: Negative Ground (Case Isolated)

Power Consumption: 100 MA (No actuator current)

Maximum Actuator Current: Internally limited to 9 A continuous

Speed Sensor Signal: 0.5-50 Volts RMS

Performance Isochronous Operation/Steady State Stability: ±0.25% or better

Speed Range/Governor: 1K to 7.5K Hz continuous

Speed Drift with Temperature: ±1 Max

Idle Adjust CW: 25-85% of rated speed 

Droop Range: Adjustable from 0-5% for a 1.5 A actuator current change 

Droop Adj. Max.: (K-L Jumpered) 400 Hz., ±75Hz. Per 1.0A change

Speed Trim Range: ±200 Hz

Remote Variable Speed Range: 25 to 100% of rated speed

Terminal Sensitivity H: -105 Hz, ±15 Hz/Volt @ 5 K Impedance

Terminal Sensitivity M: -130 Hz, ±15 Hz/Volt @ 1 M Impedance

Terminal Sensitivity K: -685 Hz, ±40 Hz/Volt @ 225 K Impedance

Terminal Sensitivity N: +1000 Hz, ±50 Hz/Volt @ 8 K Impedance

Environmental Ambient Operating Temperature Range: -40 to +85 Deg. C

Relative Humidity: Up to 95%

All Surface Finishes: Fungus Proof and Corrosion Resitant

Reliability Vibration: 1G at 20 to 100 Hz.

Shock:        10 G (11 ms)

Testing: 100% Functionally Tested


More
Dongguan Tuancheng automation equipment Co., Ltd. all rights reserved.
Sales Phone: 86-769-23162896 Fax:86-769-23162896-609、23166296